Suzuki K6A-YH6 Technical/Repair Manual page 100

REPAIR
9. Apply Three Bond™ 1215 to the lower crankcase
mating surface.
13
16
17
12
Figure 7-105: Torque Sequence M10 Cap Screws
NOTE
Apply a liberal amount of clean engine oil to lower
crankcase main bearings and crankshaft main bearing
journals.
10. Install lower crankcase to cylinder block.
NOTE
Apply engine oil to the threads of M10 cap screws and
washers and install as shown.
11. Using a 12-point 10 mm socket, tighten eight screws
7
and washers sequentially (12 through 19) to 30 lb-ft
(40 N•m).
Loosen all cap screws in the reverse order.
Tighten eight screws and washers sequentially
(12 through 19) to 30 lb-ft (40 N•m).
Torque cap screws sequentially (12 through 19) to
final specification.
Lower Crankcase (M10) Cap Screw Torque: 42 lb-ft
(57 N•m)
7-46
14
18
19
15
TN0755
21
24
20
Figure 7-106: Torque Sequence M8 Cap Screws
IMPORTANT
The remaining two M8 main bearing cap screws are
installed with the crankshaft baffle. (See "Crankshaft
Baffle" on page 7-32.)
12. Using a 12-point 8 mm socket, tighten six screws and
washers sequentially (20 through 25) to specification.
Lower Crankcase (M8) Cap Screw Torque: 212 lb-in.
(24 N•m)
22
25
23
TN0755