Jet JJ-6CSDX Operating Instructions And Parts Manual page 9

6.4 Installing Fence to Bed
Refer to Figure 6-4:
1. Take the lock handle (E), flat washer (F),
and lock nut (G) from the
2. Place the fence assembly (A) onto the table
(B). Be sure the key stock (D) on the bed
lines up with the channel (C) in the fence
casting.
3. Place the flat washer (F) on hole (H)*; insert
the lock handle (E) through the fence
casting and the table casting.
4. Thread the lock nut (G) onto the lock handle
(E). Make sure the tab on the nut faces up
and engages the slot in the table casting.
*Note: For rabbeting operations use hole (J).
Figure 6-4
6.5 Installing the Drive Belt
Refer to Figure 6-5:
1. Place V-belt (A) onto cutterhead pulley (B)
and through opening in stand.
2. Pull V-belt down and place onto motor
pulley (C).
Note: If the belt is difficult to roll on the
pulley, loosen the motor mounting screws.
3. Check to make sure that motor pulley and
cutterhead pulley are vertically aligned and
carton.
9
the V-belt does not contact the sides of the
opening in the base. If the pulleys are not
aligned, remove belt and adjust the motor
pulley in or out on the motor shaft and then
re-attach the belt.
Figure 4
4. The V-belt is properly tensioned when finger
pressure on the belt half way between the
two pulleys causes 1/2" deflection (Figure
5). If the belt is too loose, loosen the four
motor mount bolts, push down on the motor
to tension the V-belt, and tighten the
mounting bolts.
Figure 6-5
5. A new belt may have a tendency to stretch
slightly until broken in. After two hours of
operation, check
Readjust the tension if necessary.
6.6 Installing Belt Guard
Refer to Figure 6-6:
1. Place the belt guard (A) over the opening in
the stand.
2. Line up the holes in the stand with the holes
in the guard.
belt tension again.