Jet JJ-6CSDX Operating Instructions And Parts Manual page 13

5. Tighten locking handle (C, Fig 8-2).
4. Important: When the tilted operation is
finished and the fence is returned to 90°, do
not forget to flip the 90° stop block (D, Fig.
8-2) back to its original position.
To tilt fence backward
5. The fence can be tilted backward up to 45°
(that is, for a total included angle of 135°
from table surface).
6. Loosen locking handle (C, Fig. 8-2).
7. Flip the 90° stop block (D, Fig. 8-2) out of
the way.
8. Move the lever (B, Fig. 8-2) back to the
desired angle up to 135 degrees. Or you can
place
8.3 Fence stop adjustments
Periodically check the 90° and 45° backward
(135°) tilt accuracy of the fence with an angle
measuring device, such as an adjustable square
or machinist's protractor.
90º Fence adjustment
Refer to Figure 8-3:
The 90º stop is controlled by the stop bolt (E)
and the stop plate (C).
Figure 8-3
1. Set the infeed table to approximately the
same height as the outfeed table.
2. Move the fence by releasing lock handle (D)
and pushing the fence assembly until it
overlaps the tables (B).
3. Tighten lock handle (D).
4. Adjust the fence to a 90º angle by releasing
lock handle (J), pulling up on the fence
handle (A), and tightening the lock handle
(J).
Note: The stop bolt (E) should be resting
against the stop plate (C).
5. Place an angle measuring device on the
table and against the fence to confirm a 90º
setting (A, Fig. 84).
6. If the fence is not square to the table,
release the lock handle (J), loosen the hex
nut (F), and turn the stop bolt (E) until the
fence is square to the table.
7. Tighten the lock nut (F) to retain the setting.
Tighten the lock handle (J).
45º Fence backward stop adjustment
Refer to Figure 8-5:
The 45º fence backward stop (fence positioned
away from the operator) is controlled by the stop
bolt (E).
1. Loosen the lock handle (A). Move the stop
plate (D) out of the way and position the
fence at the 135º angle. Make sure the
fence sits against the stop bolt. (E).
2. Tighten the lock handle (A).
13
Figure 8-4
Figure 8-5