Replace Sensor; Position Rain Sensor; Position Rain Station - La Crosse Technology 724-2310 Instructional Manual

Replace Sensor

In the event your sensor is damaged and needs to be replaced, you
will need to delete the existing sensor's ID in order to add the replace-
ment sensor.
1. Press the SENSOR button to view sensor ID.
2. Hold the RESET button for 5 seconds to delete the old sensor's ID.
3. Install batteries in replacement sensor.
4. Press and release the SENSOR button to view sensor area (ID will
show dashes).
5. Hold the SENSOR button 3 seconds to search. When sensor
connects, the new sensor ID and the readings will show.
Note: All rain readings should still be on the station.

Position Rain Sensor

1. Mount in an open area for a more accurate rain count.
2. Install the Rain sensor on a level platform that is stationary.
3. Insert one, two, or three mounting screws (not included) through
the holes in the base of the rain sensor.
4. Ideally, the rain sensor should be mounted at least 6 ft in the
air and have a direct line of sight to the display.
5. The rain sensor should be accessible to allow for periodic
cleaning of debris or insects.
6. The maximum wireless transmission range to the rain station is
over 300 feet (91 meters) in open air, not including walls or
floors.
7. For video instruction, please visit:
http://bit.ly/Rain_SensorMounting

Position Rain Station

The station has a built-in base that allows it to easily stand on its own.
Perfect for any desk or table.
Page | 13 www.lacrossetechnology.com/support/ 724-2310