Detailed Startup Instructions
1. Insert 2- AA batteries into the rain sensor according to polarity.
•
Press the Funnel Release Tabs on each end and lift off the funnel.
•
Pinch the four Battery Released Tabs under the rocker, to access
battery compartment.
2. Insert 2- AA batteries into the rain station according to polarity.
TIME
S
E
T
Note: The station will show the
software version number for two
seconds after batteries are installed.
3. Allow sensor and station to sit together for 15 minutes before
placing sensor outside in open area.
4. Set language, time, date etc.
724-2310
Important: Remove the twist tie
from below the rocker. The twist tie
secured the rocker for shipment
ALARM
S
N
Z
www.lacrossetechnology.com/support/
Page | 4