Ltv-R1 Rain Sensor; Quick Startup Instructions - La Crosse Technology 724-2310 Instructional Manual

LTV-R1 Rain Sensor

Lets identify the parts of the rain sensor.
Base
Important: Remove
the twist tie from
below the rocker. The
twist tie secured the
rocker for shipment
Battery
Release Tabs

Quick Startup Instructions

1. Insert 2 AA batteries into the rain sensor. Observe correct polarity.
Remove the Twist Tie securing the rocker for shipment.
2. Insert 2 AA batteries into the rain station. Observe correct polarity.
3. Optional: Tip the rocker of the rain sensor to simulate rain and
receive a reading on the rain station.
4. Leave 5-10 feet apart for 15 minutes. After 15 minutes, with station
and sensor connected, move the rain sensor outside to an open
area. (Position Rain Sensor--
5. Use Setting to program the rain station.
Page | 3 www.lacrossetechnology.com/support/
Funnel
Rocker
An extra piece of plastic used for repositioning the battery
compartment correctly. After batteries are installed, make
sure this alignment tab is facing the front of the Base to
lock all four Battery Release Tabs back into place.
Page
Funnel
Release Tabs
13)
Alignment Tab
724-2310