Important Safety Information - Optelec Sentry+ User Manual

Optelec

2. Important safety information


Optelec does not assume any liability or responsibility for incorrectly
detected content of texts or their interpretation by Sentry
Please have important documents checked additionally.

Only use the Sentry

Do not expose the Sentry
temperature or humidity. These conditions may damage the
electronics or optics of the Sentry

Do not place the unit on an unstable surface. It may fall, causing
serious damage to the unit or injuries to the user.

To avoid injuries, always assemble, disassemble and handle the
components of the Sentry
and rotatable parts.

Do not expose the Sentry
avoid the risk of fire.

Do not remove any parts of the Sentry
distributor to service the Sentry
of the components as this will void the warranty. Each component
contains parts which should only be serviced by an Optelec repair
specialist.

To avoid risk of electrical damage, keep the Sentry
fluids and chemicals

Handle the Sentry
internal components.

Do not use the Sentry
devices.

Always unplug the Sentry
cloth to clean the exterior. Do not use cleaning agents or abrasive
materials as they will damage the unit.

Make sure you connect the Sentry
(AC) outlet for your safety.

Do not use the Sentry
Use of the Sentry
exclude it from warranty conditions.
English
+
[HD] indoors.
+
+
[HD] with good care as there are movable
+
[HD] to excessive heat or direct sunlight to
+
[HD] with care. Rough handling will damage the
+
[HD] near inadequately shielded medical
+
[HD] before cleaning. Use a soft damp
+
[HD] unit under 0° or above 40° Celsius.
+
[HD] other than that described in this user manual will
[HD] to extreme or rapid changes in
+
[HD].
+
[HD]. Contact your Optelec
+
[HD] if necessary. Do not open any
+
[HD] to an earthed mains power
+ +
Sentry / Sentry
+
[HD].
+
[HD] away from
Page 8
HD