Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Optelec clearview one
Summary of Contents for Optelec clearview one
- Page 1 User Manual UDC-02051 Rev. A Version 1.1 Copyright 2010 Optelec, the Netherlands All rights reserved Optelec P.O. Box 399 2993 LT Barendrecht The Netherlands Telephone: +31 (0)88 6783 444. Fax +31 (0)88 6783 400 E-mail: info@optelec.nl Website: www.optelec.com...
-
Page 3: Table Of Contents
Every effort has been made to ensure that the information contained in this user manual is correct at the time of publication. Neither Optelec, nor any of its associates, shall be held responsible for any errors or damages that may result from any incorrect use of the information contained in this manual. -
Page 4: Introduction
Please read the instructions carefully before setting up your ClearView One. Keep this user manual for future reference. Use the ClearView One indoors. Do not expose the ClearView One to extreme or rapid changes in temperature or humidity. Do not place the ClearView One near a radiator or heater, or where it may be exposed to direct sunlight. -
Page 5: Unpacking, Installation And Setup
Optelec ClearView One Always unplug the ClearView One before cleaning it. Use a soft, damp cloth to clean the exterior surfaces. Do not use any cleaning agents or any abrasive materials as these will damage your ClearView One. Only use the mains power supply provided. -
Page 6: Operation
ClearView One 4. Operation When using the ClearView One, place your hands on the wrist support at the front of the table for easier access to the control buttons, and for steady table movement. Operation – Switching ON / OFF To power the system, press the ON / OFF button that is located right above the magnification button on the reading table. -
Page 7: Semi-Colours
Please note: When the ClearView One power is off, the brake will automatically lock into position. When the ClearView One is switched on, the brake will unlock. Make sure to push the reading table backwards to its home position prior to turning off. -
Page 8: Troubleshooting
If you experience any difficulty operating the system, you can reset the factory default settings. Switch the ClearView One off and wait 3 seconds. Then press and hold the On / Off button till the red ring light, around the mode button starts flashing. -
Page 9: Compliance
WARNING: The use of accessories and cables other than those specified and sold by the manufacturer of the ClearView One, as replacement parts for components, may result in increased emissions or decreased functioning of the ClearView One. This device bears the CE, FCC and UL approval mark. - Page 10 Optelec ClearView One Humidity : < 70%, no condensation Storage & transportation conditions Temperature : -10°C to +40°C Humidity : < 95%, no condensation Date of first issue: June 2010 (Updated March 2012) Optelec Barendrecht, the Netherlands June 2010 English...
-
Page 11: Contact Information
ClearView Optelec headquarters Optelec BV Breslau 4 2993 LT Barendrecht The Netherlands T: +31 (0)88 6783 444 www.optelec.com Optelec offices worldwide Optelec NV Baron Ruzettelaan 29 8310 Bruges Belgium T: +32 (0)50 35 7555 www.optelec.be Optelec Canada Inc. 1832, Boulevard Marie-Victorin... - Page 12 Optelec ClearView Optelec US Inc. 3030 Enterprise Court Suite C, Vista, CA 92081 U.S.A. T: +1 (800) 826 4200 www.optelec.com English Page 12...
- Page 13 www.optelec.co.uk...
Need help?
Do you have a question about the clearview one and is the answer not in the manual?
Questions and answers