5.3 Connecting to 10BASE2 network
5.4 Switch settings for intelligent function module
Intelligent functional module switch settings are performed in "I/O allocation" of
GX Developer (SW4D5C-GPPW or later).
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
[2]
[1]
Set the first digit of the IP address.
If set to "No setting (Blank)", the default setting is used.
• Default value : 192
Set the second digit of the IP address.
If set to "No setting (Blank)", the default setting is used.
• Default value : 168
• Setting range : 0 to 255
Set the third digit of the IP address.
If set to "No setting (Blank)", the default setting is used.
• Default value : 250
• Setting range : 0 to 255
Set the fourth digit of the IP address. (This is the node
number.)
If set to "No setting (Blank)", the default setting is used.
• Default value : 1
• Setting range : 1 to 254
Enter the operating mode of the FL-net module.
0: Online (10Mbps, half duplex) (Default)
1: Offline
2: Loopback test
3: Hardware test
4: Online (Auto negotiation) (Mode to be selected when
using 100Mbps, theQJ71FL71-T-F01 only)
<Operating procedure>
1) As shown in figure, align the
grooves [1] and tab [2] and push in.
2) While pushing the connector in,
turn the connector to the right until
it locks.
3) Confirm that the connector has
been locked.
Contents
9