Introduction; Warnings And Safety Precautions - Kodak Portrait User Manual

INTRODUCTION

Thank you for purchasing the KODAK Portrait 3D Printer. This User Guide is
intended to provide you with guidelines to ensure that operation of this
product is safe and does not pose risk to the user.
Any use that does not conform to the guidelines described in this User Guide
may void the limited warranty.
Every effort has been made to ensure that the contents of this manual are
accurate. However Smart International, Inc. reserves the right to make
changes without notice.
You can always find the most up-to-date version of this user guide and other
instructions at support.smart3d.tech.
This product is covered by a limited one-year warranty. Coverage is subject
to limits and exclusions. See warranty for details.

WARNINGS AND SAFETY PRECAUTIONS

Refer to this user guide and take note of all safety precautions before using
your 3D printer.
Warning:
•
To prevent damage to the 3D Printer which may result in a fire or
electrical shock hazard, do not expose the 3D Printer set to rain or
excessive moisture.
•
For safety, do not place vessels or any container which contain fluid
including water, on or near the 3D Printer.
•
Do not insert any objects in the ventilation slots.
Location:
•
Place the 3D printer on a solid and flat surface capable of sustaining
the weight of the 3D printer (about 25 kg or 57 lbs. including filament
spools).
•
Adequate ventilation is essential to prevent the 3D printer failure.
Ensure that the 3D printer is placed in a position to allow a free flow of
air. Do not cover ventilation opening on the bottom cover. Do not
place the 3D printer in an enclosure or very close to walls or other
devices.
•
Avoid excessively warm locations or direct sunlight to prevent possible
damages to the 3D printer.
•
Care should be taken not to expose the set to any unnecessary
vibration, moisture, dust or heat.
Service:
•
Never attempt to disassemble this product. There are no user
serviceable parts.
•
Only use the parts provided by the manufacturer.
3