Kodak Portrait User Manual page 23

Always store your filaments along with a silica gel pack in the filament cases
or in the resealable bag. Both the silica gel and the resealable bag are
provided with KODAK 3D Printing Filaments.
•
ilaments.
Calibrating
•
Setup » Calibration » Z Offset
Calibrate the distance between the nozzles and the build plate by
changing the Z-offset. Start with the Nozzle I first, making sure the
calibration card slides in between the nozzle and the build plate with very
little resistance, then do the same with Nozzle II.
•
Setup » Calibration » Build plate Calibration
Calibrate the build plate tilt to ensure excellent printing conditions using
the provided calibration card. The nozzle should be as close to the build
plate as possible at each of the 3 points with the calibration card sliding in
between without getting stuck.
•
Setup » Calibration » Nozzle offset
Calibrate the offset between the two nozzles for dual extrusion.
After calibrating, we recommend rebooting the Printer to
ATTENTION:
save calibration values. Turn off device and wait 15 seconds before
turning it on.
23