Kodak Portrait User Manual page 28

Canadian Department of Communications. This device complies with
Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil numérique ne dépasse pas les limites de la classe A pour les
émissions radio, comme établi dans la norme des appareils créant des
interférences intitulée "Appareils numériques", ICES-003 du Département
canadien des Communications. Ce produit répond aux exigences des
normes RSS exemptes de licence d'Industrie Canada. Le fonctionnement
est soumis aux deux conditions suivantes: (1) cet appareil ne devra pas
causer d'interférences, et (2) cet appareil doit accepter toutes les
interférences, y compris celles pouvant entraîner un dysfonctionnement.
For Customers in Europe
European Community Compliance Statement
This product is in conformity with the protection requirements of EU
Council Directive 2014/30/EU on the approximation of the laws of
the Member States relating to electromagnetic compatibility.
KODAK or Smart International cannot accept responsibility for any
failure to satisfy the protection requirements resulting from a non-
recommended modification of the product.
Environmental
Restriction of the use of certain hazardous substances in electrical
and electronic equipment (RoHS)
KODAK Portrait 3D Printer does not contain any of the substances in
excess of the maximum concentration values ("MCVs") in EU
Directive 2002/95/EC, as amended by Commission Decision
2005/618/EC, and/or in the recast RoHS Directive 2011/65/EU,
Annex II, unless the substance is in an application that is exempt
under the RoHS Directive 2002/95/EC, as amended, and/or under
Annex III or Annex IV to the recast RoHS Directive 2011/65/EU. The
MCVs are by weight in homogeneous materials. This information
represents Smart International's knowledge and belief, which may
be based in whole or in part on information provided by third party
suppliers to Smart International.
Waste Electrical and Electronic Equipment Statement (WEEE)
This symbol on the Product or on its packaging indicates that
KODAK Portrait 3D Printer must not be disposed of with your other
household waste. Instead, it is your responsibility to dispose of your
waste equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment. The
separate collection and recycling of your waste equipment at the
time of disposal will help to conserve natural resources and ensure
that it is recycled in a manner that protects human health and the
environment. For more information about where you can drop off
28