Printing - Kodak Portrait User Manual

Unloading the filament
If you wish to unload the current filament, go to the "Filaments" screen
(Settings » Filaments » Unload), and follow the indications provided
onscreen.
Changing the filament
To change filament, from the "Filaments" screen select "Unload". The printer
will unload the current filament by doing a long retraction. Once the filament
is fully out of the extruder, remove the spool from the case and put it back in
its original bag, sealing it tightly so it stays dry and clean. Put the new filament
in the case as described above and hang the filament case or non-KODAK
filament spool on the metal brace at the back of the printer. Then select
"Load" and follow instructions as above.
Cae LED status lights
When your printer is ON the interior of the printer case should be lit up with a
LED light indicating the current work status of the printer:
• WHITE - Idle
• BLUE – Printing in progress
• GREEN – Print job completed
• RED – An error has occurred
These lights can be manually turned off in the manual controls (Setup »
Extras » Controls).

PRINTING

Once you have set up the printer, configured your slicer and loaded the
filament, you are ready to print!
Select an object to print
Select an object to print from the list of sample objects provided in the printer
(Print » Print from local file » Local files) or copy a previously sliced gcode
file to a USB pen drive. You can also send prints via Internet using the KODAK
3D Cloud , as explained below.
13