Certifications - Kodak Portrait User Manual

CERTIFICATIONS

Electromagnetic Compatibility (EMC)
The following Class A statements apply to features designated as
electromagnetic compatibility (EMC) Class A in the feature installation
information.
For Customers in the U.S.A.
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult a KODAK-authorized dealer or service representative
for help.
•
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
•
•
Properly shielded and grounded cables and connectors must be
used in order to meet FCC emission limits. Proper cables and
connectors are available from authorized dealers. KODAK and Smart
International are not responsible for any radio or television
interference caused by unauthorized changes or modifications to
this equipment. Unauthorized changes or modifications could void
the user's authority to operate this equipment.
For Customers in Canada
Industry Canada Compliance Statement
CAN ICES-3 (A)/NMB-3(A)
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus set out in the interference-causing
equipment standard entitled: "Digital Apparatus", ICES-003 of the
This device may not cause harmful interference.
This device must accept any interference received,
including interference that may cause undesired operation.
27