Congratulations; The Principle Behind Your Printer; Safety Information - WANHAO Duplicator 7 plus User Manual

B
you have just purchased a new type of 3D printer using Direct uv-light printing (Dup)
technology. this is a newly applied-for method of lCD image creation allow controlled uv
light get through the lCD screen which hardens liquid with the light from an uv light source.
this revolutionary system is a new way of printing that uses normal uv light as the energy
providing source to initiate the free radical polymerisation necessary to change the liquid
imagepac resin into your hardened object.

The principle behind your printer

there are two surprising advantages of this new Dup technology:
i) we can use high resolution low cost lCD screens that are widely available as monitors,
tablets, mobile phone and televisions providing phenomenal value for money, which we
pass directly onto you.
ii) the energy used by Duplicator 7 printers is again an order of magnitude lower than
used in comparable systems. this is good for your energy bills and the ecology, but there
is a huge performance advantage in that there is no unnecessary energy created. all of the
available photons strike photoinitiators and hand over their energy. in comparable Digital
light projector and laser systems there is a lot of excess energy which can lead to over-cure.

Safety Information

read the instructions carefully. keep this document for future reference. follow all warnings
and instructions marked on the product.
observe the following guidelines when connecting and disconnecting power cord to the
printer.
- insert the power cable cord into the socket at back of printer.
- turn off the printer before unplug the power cord.
- the printer cooling fan is suppose to run when you tun on the printer.
- Operate on a table or fl at, stable surface, ensuring that the machine cannot fall
and is level.
- Do not operate outdoors.
- Do not allow resin or any liquids to get inside the chassis, wipe up any
liquid spills immediately.
- store the printer in its original packaging when not in use.
- plug off the cable cord when not used for a long period of time.
after sales support
86-571-23290996

Congratulations

support@wanhao3dprinter.com support@wanhao3dprinter.com
model : Duplicator 7 plus
9