Table of Contents
Advertisement
3- Click on slice button. the code would be saved to the route you have just created.
Note: it starts to slice, that using this method of slicing take a few minutes, depending
on model size.
4- Copy and paste the fi le(*.cws) into the USB fl ash disk from where you saved it.
after sales support
14
86-571-23290996
support@wanhao3dprinter.com
support@wanhao3dprinter.com
model : Duplicator 7 plus
Advertisement
Table of Contents
Need help?
Do you have a question about the Duplicator 7 plus and is the answer not in the manual?