Lock Or Unlock A Program In The Codec - Tieline Bridge-IT User Manual

58 Bridge-IT Manual v4.0
13.17

Lock or Unlock a Program in the Codec

By default Tieline codecs will attempt to answer a call from another codec if possible. For example,
if a mono program is loaded in the codec and a stereo incoming call is detected, the codec will
adjust and load a compatible answering program.
It is also possible to lock a loaded custom program in a codec to ensure a program with your
preferred settings is not unloaded when a codec dials in. Incoming calls are generally down or up
sampled to accommodate a locked program where possible. Scenarios in which you may wish to
lock a program in the codec include:
1. Locking a dialing program to ensure the codec only dials and never answers an incoming call.
2. Locking an answering program to ensure an incoming codec call is not allowed to:
· Unload the current codec program, e.g. mono or stereo.
· Change the preferred local site settings like the jitter buffer and FEC configuration etc.
Incoming calls to an answering codec with a locked program can still specify different connection
parameters such as algorithm preferences and bit rates via session data.
1. Press the HOME
2. Select Settings and press
3. Navigate to System and press
4. Navigate to Lock Pgm (lock program) and press
Disabled.
5. When program lock is Enabled a warning message confirms program status.
6. When program lock is Disabled a warning message confirms incoming calls may load any
supported factory program.
7. Press the RETURN
Important Note: It is only possible to lock custom programs in a codec. If Lock Program
is enabled and you load a new custom program in the codec, Lock Program remains
enabled and locks the most recently loaded custom program.
button to return to the Home screen.
.
.
button to exit the warning message.
to toggle between Enabled and
© Tieline Research Pty. Ltd. 2019