Fryer Module Operation - Wolf IF15/S Use & Care Manual

Fryer Module Operation

Modes of Operation
LOCK MODE
In lock mode, all touch pad operations on the control
panel are disabled and the heating element is deenergized.
A steady glowing light within the "key" symbol indicates
that the module is locked. Refer to the illustration below.
• To lock the control panel, touch and hold the key
symbol for 3 seconds. Three chimes will sound and the
light within the key symbol will illuminate. The module
is now in lock mode.
• To unlock the control panel, touch and hold the key
symbol for 3 seconds. Two chimes will sound and the
light within the key symbol will go out. The module is
now in idle mode.
IMPORTANT NOTE: When the module is powered up for
the first time or if there has been a power outage, the
module will default to lock mode.
IDLE MODE
After unlocking the control panel as described in lock
mode, the module enters the idle mode of operation. All
touch pad operations on the control panel are enabled.
Temperature Power bar
LED display indicator
Lock "key"
touch pad
Control panel.
Temperature Timer LED
adjustment display
OFF ON CLEAR
touch pad touch pad
Fryer Module Operation
INITIAL START-UP
Before using for the first time, clean your fryer module
thoroughly with hot water and a mild detergent. Rinse and
dry with a soft cloth. This removes any residual oil and
grease left on the surface from the manufacturing process.
Refer to care recommendations on page 14.
When the module is powered up for the first time it will
default to lock mode. To unlock the control panel, touch
and hold the key symbol for 3 seconds.
IMPORTANT NOTE: A small amount of smoke and odor
may be noticed during the initial break-in period.
Oil must be added to the fryer basin before turning the
unit on. Burns or damage to the fryer module may
result when pouring oil into a heated fryer basin.
8