Wolf IF15/S Use & Care Manual page 11

Fryer Module Operation
Fryer Module Operation
TIMER OPERATION
The fryer module features a countdown timer located in
the control panel. Refer to the illustration below.
The timer may be set in one-minute increments up to 99
minutes. Once set, the remaining time will be illuminated
in the control panel as it counts down. The timer can be
used anytime the module is not in lock mode.
• To start the timer, touch
+ –
and hold or until the desired time is shown in the
timer display. The timer will begin its countdown in
minutes, 3 seconds after the time is set.
• A warning chime will sound when the timer has one
minute left and begins to countdown in seconds.
• When the timer reaches 0, an audible chime will sound.
The chime will continue to sound every 30 seconds
until CLEAR is touched.
+
AND
TOUCH PADS
TIMER DISPLAY
Timer controls.
+
on the timer control. Touch
–
OIL LEVEL
If the fryer module is started with no oil, the oil level is too
low or there is sediment on the bottom of the fryer basin,
the word "Lo" will appear in the temperature display.
Power to the heating element will be automatically turned
off and the module will enter lock mode.
To resume operation:
• Add oil to the fryer basin or strain the oil.
• Touch CLEAR to reset the control and begin normal
operation once the unit exits lock mode.
IMPORTANT NOTE: The control may take a few minutes to
reset after oil has been added or strained.
HOT OIL INDICATOR
When the fryer module is turned off after use, the temper-
ature display will continue to show the oil temperature
until the oil has cooled to below 140°F (60°C), even if the
module is in lock mode.
COLD ZONE
In the bottom of the fryer, there is an area that has no heat
under it called the cold zone. This area collects any water
from the food as well as food particles that separate from
dried foods. This cold area prevents oil from foaming over
as well as from breaking down over prolonged heating.
11
wolfappliance.com