Configuring The Bmc Interface; Setting The Ip Address For The Bmc Management Port - NetApp StorageGRID Webscale SG6000 Series Installation And Maintenance Manual

52 | Hardware Installation and Maintenance Guide for SG6000 Appliances

Configuring the BMC interface

The user interface for the baseboard management controller (BMC) on the SG6000-CN controller
provides status information about the hardware and allows you to configure SNMP settings and other
options for the SG6000-CN controller.
Steps
1.

Setting the IP address for the BMC management port

2. Accessing the BMC interface and changing the root password
3. Configuring SNMP settings for the SG6000-CN controller
Setting the IP address for the BMC management port
Before you can access the BMC interface, you must configure the IP address for the BMC
management port on the SG6000-CN controller.
Before you begin
• You are using any management client that can connect to a StorageGRID Webscale network.
• The client has a supported web browser.
• The BMC management port is connected to the management network you plan to use.
Steps
1. From the client, enter the URL for the StorageGRID Appliance Installer:
http://SG6000-CN_Controller_IP:8080
on page 52
on page 54
on page 55