NetApp StorageGRID Webscale SG6000 Series Installation And Maintenance Manual page 36

36 | Hardware Installation and Maintenance Guide for SG6000 Appliances
The login page for SANtricity System Manager appears.
c. Go to step 3
2. If the network does not use a DHCP server (or if an IP address was not acquired from the DHCP
server):
a. Connect the service laptop directly to management port 2 on controller A, using an Ethernet
cable.
Controller A is the top E2800 controller in the E2860 controller shelf.
b. Configure the IP address and subnet mast for the Ethernet port on the service laptop:
• IP address:
• Subnet mask:
c. Open a web browser on the service laptop, and enter this URL:
https://192.168.129.101
The login page for SANtricity System Manager appears.
3. Set or enter the administrator password.
SANtricity System Manager uses a single administrator password that is shared among
Note:
all users.
Do not complete the Set Up wizard for a StorageGRID Webscale appliance.
Attention:
The Set Up wizard appears.
4. Click Cancel to close the wizard.
Do not complete the Set Up wizard for a StorageGRID Webscale appliance.
The SANtricity System Manager home page appears.
.
192.168.129.100
255.255.255.0