Mounting Procedure; Assembly Kit - Danfoss VLT OneGearDrive Instruction Manual

Mechanical Installation
Take care when fitting transmission elements onto the
hollow shaft of the OneGearDrive, which is finished to ISO
H7. Use the tapped end hole intended for this purpose
according to DIN 332.
3 3
The maximum force based on bearing life is detailed in
(Figure 3.1 and Table 3.1).
Figure 3.1 Maximum Force
Up to n2
[RPM]
50
100
200
360
Table 3.1 Maximum Force
1) X is the distance from the surface of the hollow shaft to the force
location.
8
F
Rzul
X
F [N] up to X (in [mm]) 1)
RZUL
0.98 1.97 2.95 3.94
[25] [50] [75] [100]
170 148.2 131.3 117.9
[4319] [3763] [3335] [2994]
119 103.7 91.9 82.5
[3023] [2634] [2334] [2096]
68 59.3 52.5 47.2
[1727] [1505] [1334] [1198]
55.3 48.2 42.8 38.3
[1404] [1223] [1084] [973]
Danfoss A/S © 08/2014 All rights reserved.
Instruction Manual

3.5.1 Mounting Procedure

1.
2.

3.6 Assembly Kit

6
1 Shaft
2 Disc
3 Retaining ring
4 Lock washer
0 5 Fixing screw (filister head)
6 Key
Figure 3.2 Assembly Kit
4.92
[125]
106.9
[2716]
74.8
[1901]
42.8
[1086]
34.8
[883]
Fasten the drive unit by its flange using the
torque arm (see chapter 8.6.1 Torque Arm Set).
Attach the OneGearDrive on to the driven shaft
using the means provided.
1 3 2
Holding
4 5
MG75C422