Advertisement
4.3.1 Via Power ON/OFF button
Short pressing Power button twice to activate defense status. The three LEDs will
flash slowly one by one. After 3mins, the device will enter the defense status, and the
LEDs will then flash quickly one by one.
Short press Power button twice again to deactivate defense status
4.3.2 Via Calls
Any SOS number calls the device and then ends up the call by the mobile side in 10s,
the device will enter defense status and then reply SMS "Remote setting up defense
Successful". If the SOS number does not end up the call in 10s, it will activate
monitoring function.
Any SOS number calls the device and then ends up the call by the mobile side in 10s,
it will disarm status from the arm status and then reply SMS "Remote disarm
succeeded". If not ends up the call in 10s, the device will enter voice-monitoring
status.
4.3.3 Via SMS command
Send SMS "111" to arm. And the device will reply SMS "Remote setting up defenses
Successful" if it is set successfully. Only SMS from SOS numbers is valid.
Send SMS "000" to disarm. And the device will reply SMS "Successful remote
disarm" if it is set successfully. Only SMS from SOS numbers is valid.
Note:
(1) If you put the device in the car, please do not set arm statue when you are driving
as it will activate the vibration sensor.
(2) Only SOS numbers can set arm or disarm.
(3) Device SIM card should activate caller-ID function.
4.4 Anti-theft alarm
In defense status, once there is a vibration, the device will send alarm SMS to the
SOS numbers in 10s.
If the device is located, it will send accurate GPS location to SOS numbers.
Otherwise, it will send LBS location first. Once it is located successfully in 2 minutes,
the device will send a GPS location. E.g:
Advertisement
