Getting Started With Your Water Flosser - Waterpik WP-900 Manual

Plug the cord into an electrical outlet. If the outlet is
controlled by a wall switch, be sure it is turned on.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill
with lukewarm water. Replace the reservoir over the
base and press down firmly and close the lid.
WP900E1_20016224-FAA_IM_vF2.indd 9

GETTING STARTED WITH yOUR WATER FLOSSER

Remove
Fill
Replace
Inserting and Removing Tips
Insert tip into the center of the Water Flosser
handle, pressing down firmly until tip clicks into
place. The colored ring will be flush with the top of
the handle if the tip is correctly locked into place.
Gently pull on tip to confirm it is seated properly
and locked in place.
To remove tip from the handle push the tip eject
button on the handle. The control knob will rise,
releasing the tip. Remove the tip.
Caution: Do not press tip eject button while unit
is running.
Tip Insertion
NO
Gap
Tip Removal
Tip
Eject
Button
9
Insert
Eject
3/22/12 10:57 AM