Waterpik ION, ION Professional - Cordless Water Flosser

Waterpik ION, ION Professional - Cordless Water Flosser

Advertisement

Waterpik ION, ION Professional - Cordless Water Flosser

PRODUCT DESCRIPTION

PRODUCT DESCRIPTION*The USB charger is not included in all product configurations.

  1. Power ON/OFF
  2. Handle
  3. Water ON/OFF switch
  4. Pressure control
  5. Magnetic handle cradle
  6. Handle hose swivel
  7. Tip
  8. Tip rotator
  9. Reservoir lid
  10. Reservoir
  11. Tip eject button
  12. Charging contacts
  13. Base
  14. USB Charger*
  15. USB Charging Cable

TIPS

  1. Orthodontic Tip*
    • Braces/General Use
  2. Pik Pocket™ Tip*
    • Periodontal Pockets/Furcations
  3. Plaque Seeker™ Tip*
    • Implants/Crowns/Bridges/ Retainers/General Use
  4. Classic Jet Tip**
    • General Use
  5. Implant Denture Tip**
    • Fixed Implant Bridges and Dentures
  6. Tongue Cleaner**
    • Fresher Breath

NOT ALL TIPS INCLUDED IN ALL MODELS

*Replace Every 3 months
**Replace Every 6 months

Replacement tips/attachments may be purchased online at www.waterpik.com, or by phone from Water Pik, Inc. at 1-800-525-2774 (USA). To find detailed information about tips, other accessories, and product usage please visit our website at www.waterpik.com

GETTING STARTED

Charging Unit Prior to First Use
If a USB charger is not provided, a user supplied USB charger with the following specifications is required to charge this product: USB Type-A, Rated Output: 5.0 VDC, 1.0 A. Ensure contacts on BOTH the cable and unit are clean and dry before connecting the charger. Plug the USB-charger into a wall outlet and connect the magnetic charger cable to the unit. The charge indicator on the unit will glow while charging and then begin to flash momentarily every 3 seconds when the unit is fully charged. A full charge will last for approximately 4 weeks when unit is used once a day for one minute a day. When the batteries are in need of charging (approximately 30% charge left) the charge indicator light will blink 3 times quickly to indicate that the user should consider recharging the unit. A complete recharge will take 4.5-5 hours. If you use your Water Flosser once a day or less, it is recommended that you charge it every 3-4 weeks. If you use it twice a day or more, charge the unit more frequently.

Preparing the Reservoir
Remove the reservoir, lift the reservoir lid, and fill with warm water. Replace the reservoir over the base and press down firmly and close the lid.

Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly until the tip clicks into place. The colored ring will be flush with the top of the handle if the tip is correctly locked into place. To remove tip from the handle slide the tip eject button on the handle.

Prime Unit (First Time Use Only)
Set pressure control on base to high (pressure setting No.10), point the handle and tip into sink. Turn power and water ON until water flows from the tip.

Adjusting the Pressure Setting
Set the pressure control on the base of the unit to the lowest setting (pressure setting No.1) for first-time use. Gradually increase pressure over time to the setting you prefer – or as instructed by your dental professional.

Using the Water Flosser
Always place the tip in your mouth before turning the unit power ON.
With water switch on handle in OFF position, turn power on. Lean over sink and slightly close lips enough to prevent splashing while still allowing water to flow from mouth into the sink. Turn water switch ON. When finished, turn water switch and power OFF. During use you can stop the flow of water by sliding the water switch on handle to the OFF position.
NOTE: Motor will continue to run.
For best results, start with back teeth and work toward the front teeth. Direct the stream at a 90-degree angle to your gumline with tip in mouth. Glide tip along gumline and pause briefly between teeth. Continue until you have cleaned the inside and outside of both the upper and lower teeth.

One-Minute Timer/30-second Pacer
The Water Flosser will create a short pause at 30-seconds, to remind you to move to the other arch of your mouth and another short pause at 1-minute to signal you have reached the recommended cleaning time. The unit will continue to run without pauses until the unit is turned off. Depending on the pressure setting, some water will remain in the reservoir after 1-minute.

When Finished
Turn the power OFF. Empty any liquid left in the reservoir.
NOTE: If you used mouthwash or other solution besides water, see "Using Mouthwash and Other Solutions" section.
NOTE: NOT ALL TIPS INCLUDED WITH ALL MODELS.

TIP USAGE
Pik Pocket™ Tip

The Pik Pocket™ tip is specifically designed to deliver water or anti-bacterial solutions deep into periodontal pockets.
To use the Pik Pocket™ tip, set the unit to the lowest pressure setting. Place the soft tip against a tooth at a 45-degree angle and gently place the tip under the gumline, into the pocket.

Tongue Cleaner Tip
Set to lowest pressure setting, place tip in the center/middle of your tongue about half way back. Pull forward with light pressure. Increase pressure as you prefer.

Orthodontic Tip
To use the orthodontic tip, gently glide tip along gumline, pausing briefly to lightly brush area between teeth and all around orthodontic bracket, before proceeding to the next tooth.

CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER

Implant Denture Tip
The Implant Denture tip is specifically designed to access areas that are unreachable with a Classic Jet tip, Plaque Seeker™ tip, Orthodontic tip, or Pik Pocket™ tip. To use the Implant Denture tip, place the tip on the lingual side at one end of the implant retained denture. The opening of the tip is directed between the natural gum tissue and the denture directing the water under the denture. Slowly glide the tip along the space between the natural gum tissue and the denture until you have cleaned underneath the entire length of the denture.

Plaque Seeker™ Tip
To use the Plaque Seeker™ tip, place the tip close to the teeth so that the bristles are gently touching the teeth. Gently glide tip along gumline, pausing briefly between teeth to gently brush and allow the water to flow between the teeth.

Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash and antibacterial solutions. After using any special solution, rinse unit to prevent clogging by partially filling reservoir with warm water and running unit with tip pointed into sink until unit is empty.

Cleaning
Before cleaning, disconnect power supply/charger cable. Clean the product when necessary by using a soft cloth and mild non-abrasive cleanser.
The water reservoir is removable for easy cleaning. Place the reservoir in the top rack of your dishwasher for cleaning. We recommend air drying instead of a heated cycle.

Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of your water. If left unattended, it can hinder performance. Cleaning internal parts: add 2 tablespoons of white vinegar to a full reservoir of warm water. Point the handle and tip into sink. Turn unit ON and run until reservoir is empty. Rinse by repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.

Leakage
If leaking due to a damaged hose, replacement hoses and handles can be purchased at www.waterpik.com or contact Water Pik, Inc. customer service for a self service repair kit.

BATTERY REMOVAL

The rechargeable lithium-ion battery inside this product cannot be replaced and shall be removed at the end of the product's life prior to recycling.
This process is not reversible and voids the product warranty.
Observe basic safety precautions when you follow the procedure below. Be sure to protect your eyes, hands, fingers and the surface on which you work. Deplete the battery charge until the unit no longer operates prior to battery removal.

  1. Turn unit over. Remove product label (Model WF-12 Only).
  2. Remove the 4 rubber feet by carefully prying them upward with a small flat head screwdriver.
  3. Remove 5 screws from the indicated areas with a small Phillips head screwdriver.
  4. Turn unit upright and remove reservoir and reservoir lid.
  5. Remove upper housing by pulling it upward as shown.
  6. Remove screws from the indicated areas with a small Phillips head screwdriver.
  7. Pull circuit board assembly aside. Remove 4 screws from the indicated areas with a small Phillips head screwdriver.
  8. Lift up battery cover as shown.
  9. Remove battery from housing.
  10. Cut the black battery wire with a pair of scissors or side-cutters then cut the red battery wire.
    NOTE: DO NOT CUT BOTH BATTERY WIRES AT THE SAME TIME.
  11. Please recycle the unit and the battery per local or state requirements.

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USING.

  • This product is for household use.
    When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following:


To reduce the risk of electrocution:

  • Do not handle the *USB charger with wet hands.
  • Do not place or drop the *USB charger into water or other liquid.
  • Do not use this product while bathing.
  • Do not place or store this product where it can fall or be pulled into a tub or sink.
  • Do not reach for this product if it has fallen into water. Unplug from electrical outlet immediately.
  • Check the charging cord and *USB charger for damage before the first use and during the life of the product.


To reduce the risk of burns, electrocution, fire, or injury to persons:

  • Use this product only as indicated in these instructions or as recommended by your dental professional.
  • Use only the USB charger provided. If a USB charger is not provided, a user supplied USB charger with the following specifications is required to charge this product: USB Type-A, Rated Output: 5.0 VDC, 1.0 A.
  • Do not plug this device into a voltage system that is different from the voltage system specified on the device or charger.
  • Keep the charging cord and user supplied *USB charger away from heated surfaces.
  • Do not use the Water Flosser for more than 5 minutes in each two hour period.
  • Do not direct water under the tongue, into the ear, nose or other delicate areas. This product is capable of producing pressures that may cause serious damage in these areas. The potentially deadly amoeba,Naegleria fowleri, may be present in some tap water or unchlorinated well water and may be fatal if directed into the nose or ear.
  • If your physician advised you to receive antibiotic premedication before dental procedures, you should consult your dental professional before using this product or any other oral hygiene aid.
  • Fill reservoir with warm water or other dental professional recommended solutions only.
  • Do not use iodine, saline (salt solution), or water insoluble concentrated essential oils in this product. Use of these can reduce performance and will shorten the life of the product.
  • Only use tips and accessories that are recommended by Water Pik, Inc.
  • If the Pik Pocket™ tip (not included in all models) separates from the shaft for any reason, discard tip and shaft and replace with a new Pik Pocket™ tip.
  • Magnetic field: Pacemakers and similar implanted medical devices may be affected by magnet.
  • Do not drop or insert any foreign object into any opening on the product.
  • Do not use this product outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
  • Remove any oral jewelry prior to use of this product.
  • Do not use if you have an open wound on your tongue or in your mouth.
  • There are no consumer serviceable parts in this product and it does not require maintenance.
  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.
  • If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.
  • Do not use this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into any liquid. Contact Water Pik, Inc. at 1-800-525-2774 or visit www.waterpik.com.

*The USB charger is not included in all product configurations.

SAVE THESE INSTRUCTIONS

SYMBOLS
The following symbols may appear on your product and/or packaging. Some of these symbols may not be relevant in your region and are listed for information purposes only.
Symbol Definition Symbol Definition
Refer to instruction manual Detachable Power Supply
Manufacturer Direct Current (DC) Voltage
IPX7 or IPX4 Ingress Protection Code Alternating Current (AC) Voltage
IEC Class II Equipment Do not immerse this device in any liquid.
Do not use this device in a shower, bathtub and do not immerse in any liquid. UK Conformity Assessed
Authorized Representative in the European Community Regulatory Compliance Mark
CE marking of conformity Separate collection for waste electrical and electronic equipment.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Waterpik ION, ION Professional - Cordless Water Flosser

Advertisement

Need help?

Need help?

Do you have a question about the ION and is the answer not in the manual?

Questions and answers

Table of Contents