Waterpik Waterflosser WP-900 Quick Start Manual

1
Prepare the Reservoir:
Lift the hinged reservoir lid and remove the
reservoir from base and fill with lukewarm water.
Remove
Replace the reservoir onto the base,
PRESSING DOWN FIRMLY
full seating. There should be no gap
between the reservoir and the base.
3
Prime Unit (First Time Use Only):
Prior to Very First Use of Unit, Prime Unit:
Set pressure control dial on base to
the handle and tip into sink. Turn unit
water flows from the tip, turn unit
High
High
This device is only compatible with a voltage system of 120VAC, 60Hz. Do not plug this device into a voltage system that is different.
QUICK START GUIDE
Replace
NO
Gap
to ensure
high,
point
ON
until
OFF.
2
Select and Insert Tip:
Insert
4
Adjust Pressure and Pause Control:
For first time
users, adjust
pressure control
to lowest position.
Gradually increase
pressure to your liking.
Low
Model WP-900
NO
Gap
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap
between handle and
colored tip ring.
You can temporarily stop
water flow by pressing
the pause button on
the handle.
Pause
continued on back