Rigging The Fixture - Robe Robin CycBar UV User Manual

Robin CycBar UV

3.2 Rigging the fixture

The Robin CycBar UV can be rigged in any orientation on a truss without altering its operation characteristics.
For overhead use, always install a safety cable that can hold at least 10 times the weight of the fixture. You must
use only a safety wire with a snap hook with screw lock gate.
Use the safety eyelet on the mounting brackets for a safety cable attachment.
Ensure that the structure (truss) to which you are attaching
the fixture is secure
Fixture may cause severe injuries when crashing down! If you have doubts concerning the safety of a possible
installation, do not install the device and consult installation with an expert.
Truss installation
1. Bolt clamps (1) to the omega holders (2) with M12 bolt and lock nut through the hole in the omega holder.
2. Fasten the omega holders to the brackets of the Robin CycBar by inserting both ¼ turn quick locks (3) into
the holes of the brackets and tighten fully clockwise.
3. Clamp the fixture on a truss (5) and tighten both rigging clamps.
4. Pull a safety wire (4) around the truss (5) and lock its screw lock gate in the attachment point (6) as shown on
the picture below.
The Robin CycBar UV can also stand on two mounting brackets on a flat surface.
If you have doubts concerning the safety of a possible installation, do not install the device and consult installation
with an expert.
7