Starting The Generator - Chicago Electric 92280 Assembly And Operating Instructions Manual

10,000 watt (11,000 peak) generator with 18 hp robin engine

Hide thumbs

Table Of Contents

Table of Contents

Generator Electrical Controls and Outlets

120 vaC Circuit Breaker

reset Button for outlet Below

120 vaC outlet

3-Prong standard

240 vaC Circuit Breaker

reset Button for outlet Below

120/240 vaC outlet

4-Prong locking nEMa # l14-30

Warning: This product contains or, when used, produces a chemical known to

the State of California to cause cancer and birth defects or other reproductive harm.

(California Health & Safety Code § 25249.5, et seq.)

Check oil level by pulling out the oil dip stick. add oil if necessary. Never run with

low or no oil.

open the Gas valve by turning it counterclockwise until it stops. refer to the

Generator Engine Controls photo on page 13.

Place the locking key into the ignition and turn the on/off switch to the on position.

if the Engine is cold, pull the Choke Control rod. otherwise, continue with the next

step.

NOTE: DO NOT ATTEMPT TO ADJUST THE ENGINE'S THROTTLE! This engine

uses a governor device to automatically control the engine's speed. If the

throttle is adjusted, it may result in decreased efficiency and/or damage to the

unit.

Turn (and hold) the locking key to the sTarT position until the engine starts.

release the locking key. Try again in a few minutes if it does not start immediately.

refer to the robin subaru

persist. Let the engine run for five minutes to warm up before applying the electrical

load.

skU 92280