Muffler Installation - Chicago Electric 92280 Assembly And Operating Instructions Manual

10,000 watt (11,000 peak) generator with 18 hp robin engine

Hide thumbs

Table Of Contents

Table of Contents

locate the axles (24) and slide them into each axle retainer. refer to the photo at the

bottom of page 10.

align the side mounting hole of the axle with the hole in the axle retainer.

Place a Hex Bolt (27) into the bottom of the Frame, through the axle retailer, and

screw into the top nut. securely tighten.

Before mounting the Wheels (25), ensure that they are inflated to a pressure between

15 and 20 Psi. Pressures over 24 Psi could cause the tire to burst.

slide the Wheel over the axle and lock in place by placing the Cotter key (32) into the

end of the axle. Bend the Cotter key to keep it from falling out. see the illustration at

the bottom-right of page 10.

repeat steps 4 through 7 on the other axle and Wheel.

Using the front Handles (11), lift the Generator high enough to remove the two blocks.

Using the front Handles (11), lift the Generator high enough to place the two six inch

blocks under the Frame (4) at the cross bar. see illustration below.

if not already installed, mount the rubber Foot into the Front support Bracket (26) as

shown below. securely tighten.

attach the Front support Bracket (26) to the underside of the cross bar using two Hex

Bolts (29) and two Hex nuts (28). securely tighten.

Using the front Handles (11), lift the Generator high enough to remove the two blocks.

Front support

Bracket (26)

rubber Foot

Find the Muffler and verify that the Flange Gasket is present. Refer to the illustration

at the top of page 12.

Mount the Muffler Inlet (with Gasket) to the Engine (2) exhaust manifold using two M8

x 1.25" Bolts (supplied). Before tightening Bolts, verify that the gasket is centered on

the exhaust manifold.

Slide the Muffler Cover (19) over the Muffler and secure with eight M6 x 1" Screws

(48). refer to the photo at the top of page 12.

skU 92280

front Support Bracket Installation