Blade; Muffler; Storage - Bushranger HT2601 Operator's Manual

MAINTENANCE & CARE

Blade

• Every 1-2 hours, add grease to the blade.
Blade Sharpening
1. Start the engine, allow the blade to run at low speed, stagger the up and down blade for 2mm, and stop the engine.
2. After fixing the unit, sharpen the cutting edges with a flat or a grinder.
3. Start it again, stagger the blade for 2mm, then stop it.
4. Sharpen the side blade as described in step 2.
5. Lastly, coincide the blade ,and starpen the top of the blade.

Muffler

• Every fifty hours, please remove the muffler, clear the inner carbon deposit with screw driver, at the same time clean
the carbon from the exhaust port.

Storage

If you fail to follow these instructions correctly before storing the machine, deposits may form
on the interior of the carburettor & may result in the engine being more difficult to start or the
machine suffering permanent damage.
Storage Preparation
1. Carry out all the maintenance work require prior to storing.
2. Drain the fuel out of the tank.
3. When the fuel has been drained, start the engine.
4. Allow the engine to run at idling speed until it stops. This will clean the remainder of the fuel out of the carburettor.
5. Leave the machine to cool (approx. 5 minutes).
6. Clean the exterior housing of the machine.
7. Store the machine in a cold, dry place where it is out of the reach of ignition sources & inflammable substances.
8. Always store the hedge Trimmer on a level surface.
Fertilizers and other chemical garden products often contain substances that accelerate the rate of corrosion of metals. Do
not store the machine on or near fertilizers or other chemicals.
Before Restarting
Place fresh 2 stroke fuel mix at 40:1 into the fuel tank.
Transport
To transport the machine, first empty the petrol tank. Pump the primer to completely remove fuel from the carburettor &
empty excess from the tank. Clean coarse dirt off the machine with a brush. Do not transport with engine upside down or
on its side.
Fig. 13
11