Level 2 Programming (Adjustable Parameters); Level 2 Programming Procedure - Nice S-BAR Instructions And Warnings For Installation And Use

l
Please note that there is no relation between the force level indicated by the LEDs during the movement (which
is an absolute value) and the level indicated by the LEDs during the force (which is a relative value) program-
ming phase. See LEDs "L5" and "L6" in "Table 6".

7.3 LEVEL 2 PROGRAMMING (ADJUSTABLE PARAMETERS)

All the Level 2 parameters are factory-set as highlighted in "GREY" in "Table 6" and can be modified at any time. The parameters
can be set to a scale of 1 to 8. The check the value corresponding to each LED, refer to "Table 6".

7.3.1 Level 2 programming procedure

m
The user has maximum 10 seconds to press the buttons consecutively during the programming procedure,
after which time the procedure terminates automatically and memorises the changes made up to then.
To perform Level 2 programming:
1. press and hold the
release the button when LED "L1" starts flashing
2.
o
3. press the or button to move the flashing LED to the "entry LED" associated with the parameter to be modified
p q
press and hold the
4.
– wait roughly 3 seconds, until the LED representing the current level of the parameter to be modified lights up
– press the or
p q
release the button
5.
o
wait 10 seconds (maximum time) to exit the programming mode.
6.
l
To set multiple parameters during the procedure's execution, repeat the operations from point 2 to point 4 dur-
ing the phase itself.
LEVEL 2 FUNCTIONS (ADJUSTABLE PARAMETERS)
Entry LED Parameter
L1* Pause Time
Step-by-Step
L2**
function
L3* Motor speed
L4** FLASH output
20 – ENGLISH
button until LED "L1" starts flashing
o
button. With the button pressed:
o o
button to shift the LED associated with the parameter's value
LED (level) Set value
L1 5 seconds
L2 10 seconds
L3 20 seconds
L4 40 seconds
L5 60 seconds
L6 80 seconds
L7 120 seconds
L8 200 seconds
L1 Open - Stop - Close - Stop
L2 Open - Stop - Close - Open
L3 Open - Close - Open - Close
L4 Condominium (more than 2 sec triggers "Stop")
Condominium 2 (less than 2 sec triggers
L5
"Partial Open")
L6 Step-by-Step 2
L7 Hold-to-run
Opening in "semi-automatic" mode, closing in
L8
"hold-to-run" mode
L1 Speed 1 (30% - slow)
L2 Speed 2 (47%)
L3 Speed 3 (65%)
L4 Speed 4 (82%)
L5 Speed 5 (100% - fast)
L6 Open V3, close V2
L7 Open V4, close V3
L8 Open V5, close V4
L1 Gate open indicator
L2 Enabled if boom is closed
L3 Enabled if boom is open
L4 Warning light
L5 Boom light warning light
L6 Electric lock
L7 Suction cup
L8 Maintenance indicator
Description
Adjusts the pause time, in other words,
the time before automatic re-closure.
It is only effective if the "Automatic
Closing" function is enabled.
Controls the sequence of controls
associated with the Sbs input or the 1st
radio command.
Adjusts the motor speed during normal
manoeuvres.
Selects the device connected to the
FLASH output.
Table 6