Table of Contents
Advertisement
vigorously tighten the bolt fastening the balancing spring
6.
10
attach the balancing spring in the correct position
7.
11
if the gearmotor was previously unlocked, lock it again.
8.
8 – ENGLISH
3.7 INSTALLING THE GEARMOTOR
a
Incorrect installation may cause serious physical
injury to the person working on the system or to its
future users.
Before starting to assemble the automation, com-
plete the preliminary checks described in the "Pre-
installation checks" and "Product usage limits"
paragraphs.
If there is a support surface:
open the cubicle panel
1.
12
place the cubicle on the anchoring surface and mark the
2.
points corresponding to the slots
13
3.
move the cubicle and drill the surface through the marked
points
4.
insert 4 expansion bolts (not supplied)
arrange the cubicle properly and secure it with the appro-
5.
priate nuts and washers (not supplied).
Advertisement
Table of Contents
