Table of Contents
Advertisement
9.3 EDSP DIGITAL SELECTOR AND PROXIMITY
READER FOR ETPB TRANSPONDER CARDS
The "Bluebus" system allows for connecting up to four EDSP
digital selectors or four ETPB transponder card readers.
With EDSP it is possible to command the automation by entering
on the keyboard one of the memorised numerical combinations.
With ETPB it is possible to command the automation by simply
moving the memorised transponder card close to the sensor.
These devices are equipped with a unique code that it learned
and memorised by the control unit during the learning phase of
all the connected devices (see paragraph "Device learning").
This prevents any fraudulent attempt to replace a device and
any unauthorised person from commanding the automation. For
further information, consult the EDSP and ETPB instruction man-
ual.
9.4 CONNECTING THE BOOM LIGHTS (OPTIONAL
ACCESSORY)
To perform the installation:
1.
put the boom in the vertical position
loosen the 4 screws that fasten the boom cover (A)
2.
46
A
remove the boom temporarily
3.
insert the cable grommet through the specially configured
4.
hole (B)
47
28 – ENGLISH
feed the lights cable (C) through the rubber impact pro-
5.
tector and, if necessary, use a fish tape to facilitate the
operation
48
6.
if necessary, shorten the lights cable by cutting it only in
one of the points indicated by an appropriate mark. After
cutting the cable, the cap of the cut end must be shifted
to close the new end
insert the wiring cable first through the hole on the boom
7.
support then through the hole in the cubicle
a
leave a bit of cable inside the boom support, so that
the boom can be rotated without causing any ten-
sion along the cable.
49
B
connect the lights cable to the "FLASH" terminal on the
8.
control unit
C
S T
O P
C
Advertisement
Table of Contents
