Table of Contents
Advertisement
5. Set aside the old Windows 7 drive (and CPU board assembly, if replaced) in case you later
discover you need a file from the old drive.
6. The PNA does not come with any antivirus software installed. You may want to install an
antivirus program before connecting the PNA to the Internet. You may also want to download
and install any recent Windows Updates.
7. This upgrade kit contains PNA firmware revision A.13.30.xx. You may want to verify that this is
the most recent firmware revision available for Windows 10 at:
http://na.support.keysight.com/pna/firmware.
8. The upgrade is now completed, and the PNA is ready for use.
Installation Note N8985-90001
If, after you install the Windows 10 drive, you need to access some files on
the old Windows 7 drive, use a USB 2.5-inch hard drive enclosure. These
are inexpensive and are very simple to use. Just make sure you get an
enclosure that matches your SATA hard drive interface.
You may notice that the Windows User Access Control (UAC) will prompt
you for permission to install programs or make other critical changes.
While this feature can be turned off, this is not recommended due to
security concerns.
Firmware for Windows 10 will always be A.13.30.xx or higher. Firmware for
Windows 7 will be updated to be compatible with some updated versions
of PNA firmware in parallel with the compatible Windows 10 firmware
versions. You cannot run firmware below A.13.30.xx on a Windows 10
PNA. At some point in the future, Windows 7 will not be compatible with
PNA firmware versions. To check for Windows 7 compatible firmware, refer
to http://na.support.keysight.com/pna/firmware.
The user name is "instrument" and the password is "measure4u".
Upgrade Procedure
7
Advertisement
Table of Contents
