Bevel gear/Cutting attachment
The pin screw (C) must fi rst be removed
to replace the wear guard plate (A) or the
chain adjuster screw (B).
Prise off the guard plate using a screwdri-
ver.
Lift off the chain adjuster screw and the
rubber oil channel.
The pin screw (C) must fi rst be removed
to replace the wear guard plate (A) or the
chain adjuster screw (B).
TIP!
Screw two nuts to the pin screw and lock
them together. Use the lower one to grip a
wrench and unscrew the pin screw.
Then prise off the plate using a screwdri-
ver.
Remove the chain adjuster screw.
Lift off the rubber unit (D) used as an oil
channel for chain lubrication.
Assembling, drive end
Clean and inspect all components and
replace if damaged or worn.
Assemble in the reverse order as set out
for dismantling.
Be observant of the following:
1. Check that the oil channel (A) is open
all the way to the bar and that the rub-
ber unit (B) is not damaged.
2. Replace the rubber buff ers (C) if they
are deformed and do not fi t correctly in
the chain sprocket and the drive disc.
5
45