Husqvarna 326 E Workshop Manual page 20

Electrical system
327 LS
Remove the screws holding the clutch
cover.
Remove the clutch cover complete with
the shaft from the engine.
NOTE!
Do not lose the rubber bushings fi tted between the fuel tank and the clutch
cover.
Loosen the short-circuit cable from the
ignition module.
502 50 18-01
Dismantle the ignition module and the
centrifugal clutch.
502 50 18-01
Dismantling
327 P5
Model 327 LS, 327 P5
The following components must be
dismantled for the ignition system to be
accessible.
Cylinder cover, guard over the muffl er and
spark plug.
Unhook the throttle cable from the carbu-
rettor.
Remove the three screws holding the
clutch cover on the engine.
Lift off the cover together with the shaft.
Loosen both ends of the short-circuit cable
from the ignition module.
Remove the remaining screws (A) holding
the ignition module and both screws (B)
that hold the centrifugal clutch.
Lift off the clutch, both support washers
and the ignition module.
2
19