Leakage Testing The Crankcase; Crankshaft And Crankcase - Husqvarna 326 E Workshop Manual

7
62

Crankshaft and crankcase

Check that the guide rail and its gaskets
are undamaged.
Alternativ
Leakage testing the
crankcase
Fit the two sealing plates (A).
502 54 11-02
A rail sits in the bottom of the crankcase
and has the task of guiding the fuel-air
mixture up towards and into the cylinder.
Check that the gasket (A) which lies
around the rail is undamaged and the
gaskets (B) that are to seal against the
cylinder.
Lubricate the big-end bearing with a
few drops of engine oil and position the
crankshaft in the crankcase.
Alternativ
Montera vevaxel/kolv först i cylindern och
placera därefter enheten på vevhuset.
Assemble all the remaining parts in the
reverse order as set out for dismantling.
See respective sections if necessary in
the Workshop Manual.
Leakage testing the
crankcase
Remove the cylinder cover, spark plug
and grille over the muffl er
Loosen the screws holding the carburet-
tor suffi ciently so that the sealing plate
no. 502 54 11-02 (A) can be slid down
between the carburettor and partition.
It may be necessary to carefully pry out
the carburettor suffi ciently using a screw-
driver.
Place a plate (A) between the cylinder and
heat guard by the muffl er.
NOTE!
Press down the sealing plates as
far as possible between the bolts to
ensure a proper seal.