Important Safety Information - Tektronix AFG1022 Technical Reference

Important safety information

General safety summary
To avoid fire or personal injury
AFG1000 Series Specifications and Performance Verification
This manual contains information and warnings that must be followed by the
user for safe operation and to keep the product in a safe condition.
To safely perform service on this product, additional information is provided at
the end of this section. (See page v, Service safety summary.)
Use the product only as specified. Review the following safety precautions to
avoid injury and prevent damage to this product or any products connected to
it. Carefully read all instructions. Retain these instructions for future
reference.
Comply with local and national safety codes.
For correct and safe operation of the product, it is essential that you follow
generally accepted safety procedures in addition to the safety precautions
specified in this manual.
The product is designed to be used by trained personnel only. Only
qualified personnel who are aware of the hazards involved should remove
the cover for repair, maintenance, or adjustment.
Before use, always check the product with a known source to be sure it is
operating correctly.
This product is not intended for detection of hazardous voltages. Use
personal protective equipment to prevent shock and arc blast injury where
hazardous live conductors are exposed.
While using this product, you may need to access other parts of a larger
system. Read the safety sections of the other component manuals for
warnings and cautions related to operating the system. When incorporating
this equipment into a system, the safety of that system is the responsibility of
the assembler of the system.
Use proper power cord.
and certified for the country of use.
Use proper voltage setting.
selector is in the proper position for the source being used.
Ground the product.
This product is grounded through the grounding conductor
of the power cord. To avoid electric shock, the grounding conductor must be
connected to earth ground. Before making connections to the input or output
terminals of the product, make sure that the product is properly grounded.
Use only the power cord specified for this product
Before applying power, make sure that the line
iii