Introduction; Purpose Of The Manual; Overview Of Documentation - Danfoss VLT MCB 150 Operating Instructions Manual

Introduction

1 Introduction

1.1 Purpose of the Manual

NOTICE
Retain this documentation for instruction and for future
reference.
These Operating Instructions explain the function and
operation and provide installation and wiring guidelines
for the safety option.
Also refer to the following documents from the motion
control range:
•
MCT 10 Set-up Software Operating Instructions
describe the configuration of the safety option.
•
®
VLT AutomationDrive FC 301/FC 302 Operating
Instructions describe the frequency converter.
•
The online help for the MCT 10 Set-up Software
describes how to set the parameters for the
frequency converter and the safety option.
Be conversant with the information in these documents to
fully understand this manual.
®
VLT is a registered trademark.

1.2 Overview of Documentation

Chapter 1 Introduction
Explains the contents, structure and specific order of this
manual.
MG34W302
Operating Instructions
Chapter 2 Legal Information and Safety
Provides information on the most important product
features.
Chapter 4 Installation
Explains how to install and wire the product.
Chapter 5 Commissioning
Describes how to commission the product.
Chapter 6 General Parameter Set-up
Describes the basic parameters for setting.
Chapter 7 Service and Repair
Describes how to replace a defective safety option and
how to update, service and modify its firmware.
Chapter 8 Warnings and Alarms
Contains a table overview of the warnings and alarms.
Troubleshooting tips are also part of the overview.
Chapter 9 Technical Specifications
Specifies the technical details of the safety option.
The manuals listed below contain important information
about safety systems that must be used to mount and set
up the speed monitoring safety functions of the safety
option module.
Danfoss A/S © Rev. 2014-02-11 All rights reserved.
1 1
5