Danfoss VLT MCB 150 Operating Instructions Manual page 50

Service and Repair
LCP Copy
Message
0 RPM
Password
0-69 Password Protection
of safety Parameter
[1] Enabled
0 RPM
Copy/Save
0-50 LCP Copy
[ ] 9
Safety Par. from LCP
7 7
0 RPM
Safety Par. from LCP
Copying...
0 RPM
Safety Password
Please enter the safety
Password
0 0000000
0 RPM
Pa
0-
Password accepted
[0
0 RPM
Pa
0-
Password rejected
[0
48
None
1(1)
The password protection of the safety parameters is enabled.
([0] Disabled)
None
1(1)
0-5 *
Copying the safety parameters from the LCP into the frequency converter is selected.
None
1(1)
The safety parameters get copied from the LCP into the frequency converter.
00%
None
1(1)
If password protection is enabled in 0-69 Password Protection of Safety Parameters, enter the correct
LCP-copy/parameter mismatch password (0-68 Safety Parameters Password).
None
1(1)
If the entered password is correct, this overlay message is shown for some seconds.
([1] Enabled)
None
1(1)
If the entered password is wrong, this overlay message is shown for some seconds. Then the password
can be entered again.
([1] Enabled)
Danfoss A/S © Rev. 2014-02-11 All rights reserved.
Operating Instructions
Description
MG34W302