Specifications - DSC PowerSeries Neo Installation Instructions Manual

Installation Instructions
The HS2TCHP keypad can be used on security systems with up to 128 zones. These
keypads are compatible with the Neo PowerSeries HS2016/32/64 and HS2128 panels
V1.0 and higher.

Specifications

Temperature range: UL/ULC: 0°C to +49°C (32°F to 120°F); EN: -10°C to +55°C
l
(14°F to 131°F)
Weight: 405g
l
Humidity (MAX): 93%R.H. non-condensing
l
Plastic enclosure protection degree: IP30, IK04 (touchscreen excluded)
l
Voltage rating: 11.3VDC to 12.5VDC nominal
l
Low battery indication: 9VDC
l
Connects to control panel via 4-wire Corbus
l
Corbus distance: 101 m (332 ft.) (max.); Corbus distance in Extra Power mode: 54
l
m (177 ft)
Up to 16 keypads per system
l
HS2TCHP current draw (at 12VDC): 100 mA standby (screen off)/160 mA activ-
l
ated or alarm (reg. power mode)/230 mA activated or alarm (Extra Power mode).
Note: This does not include 50 mA (max) using PGM output.
l
Wall mount tamper
l
Five programmable function keys
l
Ready (Green LED), Armed (Red LED), Trouble (Yellow LED), AC (Green LED),
l
HOME (White LED)
Keypad size: 191 mm x 126 mm x 20.35 mm
l
Display area size: 155 mm x 86 mm
l
SD card slot: holds any standard Secure Digital (SD) card* (32 x 24 x 2.1 mm). *If
l
necessary, the SD card can be formatted to file system FAT16 or 32 using a PC.
The maximum size SD card supported is 32 GB.
Wiring: standard four-wire connection
l
View angle: horizontal viewing angle: 70° (left) (typ.) 70° (right) (typ.)
l
Vertical view angle: 70° (top), 50° (bottom) (typ.)
l
Brightness: 280 cd/m2
l
English Unpacking
The keypad package includes the following parts:
One keypad
l
Five mounting screws and five anchors for wall-mounting
l
One tamper switch (required for UL commercial burglary listed installations)
l
Installation instructions and User manual
l
Mounting
Mount the keypad where it is accessible to designated points of entry and exit. Once a
dry and secure location is selected, do the following:
1.
Remove the SD card before opening the touchscreen. See the following figure.
Warning: Do not disassemble the touchscreen without removing the SD card
first.
2.
Remove screw at the bottom of the keypad.
3.
Insert screwdriver into slots and pry up to remove.
Figure 1 - Removing the Backplate
gently
push
in
4.
Secure keypad backplate to the wall using mounting holes. See the following fig-
ure. Use all 4 screws provided unless mounting on a single gang box. Use the
plastic anchors if the unit is to be mounted on drywall. If using the keypad
tamper, secure the tamper plate to the wall with a screw.
press
to
eject