Advertisement
Wall Plate
5
Mount the wall plate and tighten with the provided lag bolts (A) and D6 washers (C)
using a socket wrench.
Do NOT use power drill and do NOT over tighten the lag bolts.
NOTE
Do NOT use concrete / brick anchors (B) for drywalls.
Mounting to a Concrete or a Brick Wall
2b
Level
1
Hold the marking template provided against the wall where you want to install the TV, mark
three holes for drilling.
5
C
A
SKIP TO STEP 3
Marking Template
70mm
70mm
(2.7")
(2.7")
ø 10mm
(ø 3/8")
2
Using a power drill and a 3/8" masonry drill bit, drill mounting holes of 3/8" (10 mm) diameter
and 2.7" (70 mm) depth at the marked locations in the previous step.
WARNING
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
Concrete Wall
3
Place concrete anchors (B) in each hole. Tap each anchor flush with the wall using a hammer.
Mount the wall plate and tighten with the provided lag bolts (A) and D6 washers (C) using
a socket wrench.
B
C
A
6
Advertisement
