Advertisement
1
Remove the VESA Plate
VESA Plate Screws
Loosen and remove the VESA plate screws on the VESA plate as shown above.
VESA Plate
Lift and remove the VESA plate from the mount.
WARNING
Make sure that mounting screws are anchored into the center of the studs. The use
of a stud finder is highly recommended.
Installers are responsible to provide hardware for other types of mounting situations.
Installers must verify that the supporting surface will safely support the combined
TIP
weight of the equipment and all attached hardware and components.
3
2a
Mounting to a Wooden Stud Wall
Stud Finder
1
Using an edge-to-edge stud finder, find the
edges of the stud.
Marking Template
3
Using the marking template provided, mark
three holes for drilling on the centerline of the
stud.
For concrete or brick
NOTE
wall mounting, follow
Step 2b.
2
Using a level, mark the centerline of the stud.
65mm
65mm
(2.5")
(2.5")
ø 4.5mm
(ø 3/16")
4
Using a power drill and 3/16" drill bit, drill
pilot holes of 3/16" (4.5mm) diameter and at
least 2.5" (65mm) depth at the marked
locations in the previous step.
4
Advertisement
