Connecting The Smart Remote 4 To Your Ultimatte - Blackmagicdesign Ultimatte 12 Operation Manual

TIP The power adapter's outside screw ring also serves as the negative contact,
with the positive contact being the center pin of the connector. If you want to secure a
ground connection to the chassis of your Smart Remote 4, you can attach it to the
terminal lug located next to the power input.

Connecting the Smart Remote 4 to your Ultimatte

Connect the Smart Remote 4 to your Ultimatte 12 via Ethernet using a standard CAT 5e or CAT
6 Ethernet cable. We recommend using a CAT 6 shielded cable as it will prevent any potential
interference from nearby equipment.
AC IN USB
ETHERNET
Plug your Ultimatte main unit into the Smart Remote 4's left side Ethernet port using a CAT6 Ethernet cable
The Ultimatte 12 main unit has a default IP address of 192.168.10.220. If you are using a new
smart remote with your Ultimatte 12, then the smart remote will automatically detect the main
unit so you won't need to change any IP settings.
If you are connecting an Ultimatte 12 to a network that uses a different IP address, subnet mask
and router, you can change the IP settings for your Ultimatte to suit your network. Refer to the
'connecting to a network' section for more information.
REF GPIO BG BG MATTE
OUT LOOP LOOP LOOP
IN IN IN IN
G MATTE FG H MATTE LAYER LAYER MATTE PGM FILL
LOOP LOOP LOOP LOOP LOOP 1
IN IN IN IN IN 2
MATTE TALENT MONITOR
1 1 1 OUT
2 2 2 IN
Getting Started 7 7