Advanced Programming - Graco G3 Pro Instructions Manual

Advanced Programming

There are 2 Advanced Programming options. The following Table identifies each option and when it is used.
Advanced
Setting
Option
A1 Lockout
Code
(Optional)
A2 Low Level
Alarm Time
Entering a PIN Code for the First Time
A1-Setting Up PIN Code
A PIN Code can be programmed into the G3 to protect
the settings from inadvertently being changed by unau-
thorized users.
1. Press the UP ARROW button for 10
seconds.
The LED next to the LOCK ICON on the dis-
play lights, indicating you have entered the
PIN Mode.
2. The word OFF appears in the
display. Press the UP or
DOWN ARROW button to
change this to ON.
3. Press the ENTER button to enter the
PIN Code.
4. The cursor automatically is
positioned to entered the first
character of the PIN Code.
Use the UP and DOWN
ARROW buttons to move up
and down through the numbers 0-9 until the first
number in the PIN code is displayed in the field.
5. Press the ENTER button to set the num-
ber. The cursor automatically moves to
the next number field.
332298E
Format/ Description
Secures setup modes with PIN
MM:SS (minutes:seconds) sets
amount of time between Low Level
Warning to Low Level Fault.
Default = 3 minutes
Why Use This?
Prevents unauthorized users to adjusting settings.
To accommodate most lubrication situations, a con-
servative amount of time is programmed between
the low level warning and fault to help protect unit
from running dry. If necessary the amount of time the
unit runs before stopping due to a low level fault can
be adjusted.
6. Repeat steps 4 and 5 for each PIN Code prompt
field.
7. Press the ENTER button to save the
PIN Code and exit Advanced Setup.
Entering Advanced Setup
Press the UP ARROW button for 10 sec-
onds.
If the G3 was previously set up to require a
PIN Code, the LED next to the LOCK ICON lights, indi-
cating a PIN Code is required.
1. The cursor is automatically
positioned to enter the first
character of the PIN Code.
Use the UP and DOWN
ARROW buttons to move up
and down through the numbers 0-9 until the first
number in the PIN code is displayed in the field.
2. Press the ENTER button to set the num-
ber. The cursor automatically moves to
the next number field.
3. Repeat steps 1 and 2 for each PIN Code prompt
field.
If the PIN Code you entered is correct, the first editable
character on the display will flash.
Advanced Programming
29