Care of Sweden CuroCell NEO CX13 User Manual page 7

A. Autofirm
Autofirm is used to fill the mattress completely with air for firm support. The pump always
starts in this mode. When the correct pressure is reached, it changes automatically to the
previous setting or to the presetting outlined below.
Presetting features for Autofirm process
1. Program (Therapy): Select the required program.
2. Comfort setting: Set the required air pressure (1-10).
3. Cycle time: Select from 10, 15, 20 or 25 minutes.
Note: The preset Cycle Time, Comfort Level and Therapy mode will be illuminated to indicate
the settings during the Autofirm process. (Autofirm LED is also illuminated.) After mattress is
inflated, Autofirm LED will be turned off automatically.
B. Alternate
In this mode, the pressure alternates between the cells and there are four different cycle times
to choose from.
C. Static
When" Static" is chosen, the alternating process is terminated and the pressure between the
cells evens out. The function can be used in association with patient care,
repositioning/transferring in and out of bed. The function is turned off by pressing the button
again, or it will automatically go back to alternating mode after 20 minutes.
D. Seat inflation
This mode gives extra support when sitting up and can be set for both alternating and static
mode.
4 PANEL LOCK
Press down the Panel lock button for about 2 seconds to lock or unlock the panel.
5 ALARM MUTE
Press the ALARM MUTE button to temporary turn off the alarm. Should the situation not be
resolved within 5 minutes, the alarm will be activated again. Please refer to section 8 to
troubleshoot any problems with the alarm.
A. Power failure alarm
During a power failure, both the sound and light alarm will go on. Turn it off by pressing the
ALARM MUTE button.
B. Low pressure alarm
When the low pressure light is on, the pressure in the mattress is below normal. Both the light
and sound alarm will activate. The alarm will sound until the ALARM MUTE button is pressed.
If the problem remains, see chapter 8 for trouble shooting.
6 SERVICE
This light indicates a technical failure in the pump. First check that the air filter is clean and
that the pump is not covered by anything (such as a pillow or a blanket). If the problem
remains, please contact the manufacturer or your local dealer for further information.
7 POWER
Power on/off.
7