Table of Contents
Advertisement
User Manual v1.0
4. Protocol- user may choose the protocol that you would like to block on the drop down box.
5. Source IP- user may choose the Source IP address from ALL, Single and Subnet on the drop
down box.
6. IP Address- enter the Source IP address into the required field.
7. Netmask – enter the Netmask on the required field.
8. Source Port- Enter the port number that you would like to block.
9. Destination IP – user may choose the Destination IP address from ALL, Single and Subnet on
the drop down box.
10. Enable – Tick the Enable box to enable Packet filtering.
11. Click Apply to save the settings.
All manuals and user guides at all-guides.com
Page 39 of 46
Advertisement
Table of Contents
