Sierra Wireless Overdrive User Manual page 110

Enabling Port Forwarding
Before you can use or configure Port Forwarding, you must enable it.
1.
Log in to the home page.
2.
Click Advanced settings > Router > Basic
3.
Next to
Port Forwarding
4.
Click .
save
Enabling Port Forwarding for an Application
1.
Ensure you've enabled port forwarding. See "Enabling Port Forwarding" on page 102.
2.
Click
Advanced settings > Router > Port Forward
3.
In the last row of the table, click the
The values for
Start
4.
If necessary, change the range of port numbers associated with the application. Traffic will be
allowed (not blocked) if its destination port number is in the specified range.
In the field, enter the number that starts the port range.
Start
In the End field, enter the number that ends the port range.
If the range consists of only one port, enter the number that you entered in the
5.
In the list, click the protocol(s) used for this application (TCP, UDP, or both).
Protocol
6.
In the IP Address
7.
Ensure is selected.
Enable
8.
Click .
Add
9.
Click save .
Disabling Port Forwarding for an Application
1.
Ensure you've enabled port forwarding. See "Enabling Port Forwarding" on page 102.
2.
Click Advanced settings > Router > Port Forward
3.
To keep the application in the list (in case you want to re-enable port forwarding later on), clear
the check box.
Enable
— or —
To remove the application from the list:
Click the row that you want to remove.
A row of buttons (
Click .
Delete
102 Settings
, select .
Enable
Application
and ports are automatically filled in.
End
field, enter the IP address of the server to be accessed.
Delete , OK , Cancel ) appears.
.
.
field, and select the application type from the list.
.
field.
Start