Osd Menu Table - Eneo MCB-72M2712M0A Installation Manual

2. ▼ : Zoom Out
3. ◄ : Focus Near
4. ► : Focus Far
ANALOG OUT0 should be set to TVI MODE, AHD MODE or CVI MODE to get CVBS
i
video in sub-out. If it is set to CVBS, there is no CVBS video in sub-out port. (SYSTEM>
OUTPUT> ANALOG OUTPUT0)
If CVBS video is enabled through ANALOG OUT0 or Sub-out port, WDR and 3D-NR
i
functions are disabled in all video outputs. It should be considered when installer adjusts
the video with installation monitor via CVBS video signal.

OSD menu table

Press the 'OSD menu SET key' down to access the setup menu mode.
• EXIT : Enters 'EXIT' menu with save current setting or without save.
• RETURN : Returns to the previous menu.
OSD menu table
MENU SUB MENU
DC
LENS
MANUAL
AF MODE
MODE CHANGE
SCANNING
ZOOM / FOCUS
ONEPUSHAF
SYNC TDN
INITIAL
CONFIGURATION
MODE (INDOOOR, OUTDOOR, DEBLUR)
ZOOMPUSH, MANUAL
ENABLED, DISABLED
HALF, FULL
ON
ON, OFF
ON
EN
13