SYMA GYRO REMOTE CONTROL SERIES User Manual page 10

2. Low-voltage protection:
When the four indicator lights at the bottom of drone
start flashing, it means that the drone's battery power is
low. At this time, please control the drone return.
Over-Current Protection:
3.
When the drone encounters direct impact from a
foreign object, or is obstructed, or the blades are not
rotating, the drone will go into the over-current
protection mode.
4.Level Calibration Function:
Place the drone on a level surface and at the same
time, push both left and right joysticks to the lower right
corners for 2 to 3 seconds; the indicator lights on the
drone will blink rapidly, and they will return to solid
status after about 2 to 3 seconds. The level calibration is
successful.
5.High/Low Speed Function:
Low speed by default when first powered-on. Possible
to switch the function mode of high/low speed by
pressing the right joystick for a short time. It is switched
into high speed mode when two "beep" sounds come
from the remote control, pressing the right joystick for a
short time under fast speed mode and then one "beep"
sound would come from the remote control,then it is
switched back into low speed mode.
6.Photo/ Video Shooting Function:
①Photo shooting function: Press the Photo button, the drone indicator and
the red indicator light on the camera will flash once when the photo has
been taken.
② Video shooting function: Press the Video button, the drone indicator and
the red indicator light on the camera will flash twice, and then turn long
bright, it indicates the video is recording, press the Video button again,
the indicator light on the drone is long bright, indicating the recording is
complete.
7.Adjustable function of camera
As shown on the right, press the button A or B to
adjust the camera angle in corresponding upward
or downward.
-9-
A
B